I am tring to setup and run with 3 monitors, I have a 2 monitor setup on my mother board VAG and DVI which works fine. I installed a new Graphics Card (Geforce GT 610) and hooked up the 3rd monitor to it and restarted my HP ENVY 700. At restart only the new Graphics Card the 3rd monitor showed anything the other 2 were blank.
After doing some research, I found out that you have go into the bios and change the Primary Graphics Card setting from PCI to IGP. I have gone into the bios settings to the advance tab but I can't find anything that will allow the integrated system to start up first.
Their are only 4 drop downs on the advance tab
Power on Optios
BIOS power on
BUS options
Device options
none which shows the Primary Graphics Adapter.
Am I looking in the wrong place or has something changed in the bios settings...
Joe